Please note, this module is compatible with the Advanced Cable Tester v2.
The Advanced Cable Tester v2 Connector Module: DisplayPort to DisplayPort enables testing of cables with DisplayPort on both cable ends using the Total Phase Advanced Cable Tester v2.
- Short testing - Dynamic visualization of test results
- Open testing - Dynamic visualization of test results
- Continuity testing - Dynamic visualization of test results
- DC resistance measurement for most wires, with milliohm precision on ground and power wires, ohm resolution on most other wires, continuity check only on high-speed data lines
- Signal integrity testing of data lines to 12.8 Gbps per channel
Left: passing eye diagram for DP 1.4 at 10 Gbps per lane. Right: failing eye diagram for DP 1.4 at 10 Gbps per lane
Other connector modules are available:
- USB Type-C to USB Type-C (USB 3.2 and earlier specifications). Full-featured and USB 2.0 Type-C cables are supported
- USB Type-C to USB Standard-A (USB 3.2 and earlier version specifications)
- USB Type-C to USB Micro-B (USB 3.2 and earlier version specifications)
- USB Type-C to USB Standard-B (USB 3.2 and earlier version specifications)
- USB Standard-A to USB Micro-B (USB 3.2 and earlier version specifications)
- USB Standard-A to USB Standard-B (USB 3.2 and earlier version specifications)
- Lightning (USB 2.0) to USB Standard-A
- Lightning (USB 2.0) to USB Type-C
- HDMI to HDMI (Up to 12.8 Gbps per channel)