- Manually updating firmware/license on your Advanced Cable Tester v2
- Sending a Packet with the USB Power Delivery Analyzer
- Voltage and Current Measurements with the USB PD Analyzer
- What possible bitrates do the Aardvark I2C/SPI Host Adapter support?
- Why am I seeing occasional bit corruptions when using the SPI slave functionality?
- Is the Aardvark I2C/SPI Host Adapter compatible with 5V I2C devices?
- When I power cycle my target device, the Aardvark I2C/SPI Host Adapter becomes unstable.
- I'm using the Aardvark I2C/SPI Host Adapter as an SPI Master and when I do a write, the Slave Select line is toggled before the data is sent. This causes an incorrect transmission from my slave device. What's wrong with my setup?
- I'm using the Aardvark adapter as an SPI master using mode 2 or 3. The SCK line does something strange before the actual 8 bits are transmitted. What's wrong with my setup?
- I am getting inconsistent and unexpected results when I try to use two Aardvark I2C/SPI Host Adapters cross-connected through the I2C/SPI Activity Board.
- Using the Aardvark adapter with a Microwire device
- Low Voltage I2C Interface to the Aardvark Adapter
- Proper Target Device Power Cycling Procedure
- USB vs. Serial and Parallel
- SPI performance limitations and analysis
- Monitoring an embedded USB with a Beagle USB Protocol Analyzer
- Is the Aardvark I2C/SPI Host Adapter compatible with 1.2V/1.5V/1.8V/2.5V devices?
- What are the physical dimensions of the Aardvark I2C/SPI Host Adapter, Beagle I2C/SPI Protocol Analyzer, and Cheetah SPI Host Adapter?
General Hardware