I2C SPI USB CAN eSPI Cable Testing View All Videos Quick Start Guides Software Downloads App Notes White Papers User Manuals Knowledge Base Sales Support About Us
Products Blog Sales Support Contact Search
Beagle USB 480 Protocol Analyzer Quick Start Guide
Beagle USB 480 Protocol Analyzer Quick Start Guide

Introduction

These getting started guidelines are intended to facilitate the first use of the Beagle 480 analyzer. The Beagle USB 480 analyzer can be used with Data Center or Beagle API to monitor Low, Full, or High speed USB 2.0 (up to 480 Mbps) devices. Use the Beagle USB 480 analyzer with Data Center, and follow the instructions below to monitor a USB 2.0 device.

All current downloads for the Beagle USB 480 analyzer can be found on the product page.

Getting Started Guidelines

  1. Download and run the latest version of the Total Phase USB Drivers Installer. {USB Drivers - Linux} {USB Drivers - Windows}
  2. Connect the Beagle analyzer analysis port to the computer. (?)
  3. Download and unzip the latest version of Data Center software; select from Windows, Linux, or Mac. (?)
  4. Launch Data Center. (?)
  5. Connect to the Beagle Analyzer.(?)
    1. Click Analyzer > Connect to Analyzer.
    2. Select the Beagle analyzer.
    3. Click OK to connect to the Beagle analyzer.
  6. Configure the Device Settings for High speed USB 2.0. (?)
    1. Click Analyzer > Device Settings.
    2. Choose USB in the Capture Protocol option.
    3. Configure the USB 2.0 Bus Speed to Auto detect.
    4. Configure the USB 2.0 Capture Mode to Real-time.
    5. Click OK to close the Device Settings.
  7. Configure the Capture Settings. (?)
    1. Click Analyzer > Capture Settings.
    2. Choose USB tab.
    3. Optionally configure the Capture Mode to Sequential.
    4. Optionally enable keeping Data-less Sequences for USB 2.0.
    5. Choose General tab.
    6. Change the Capture Data Limit size to the desired amount.
    7. Click OK to close the Capture Settings.
  8. Start the capture. (?)
    1. Click Analyzer > Run Capture.
  9. Connect the Beagle analyzer's target host and device ports to the target host and target device. (?)
    1. Valid configurations are shown in the Beagle user manual.
  10. The Capture Started record will be displayed in the Transaction window along with the data captured from the bus, if there was any.
  11. Stop the capture. (?)
    1. Click Analyzer > Stop Capture.
  12. Save or export the capture.
    1. Click File > Save to save the capture as a TDC file. (?)
    2. Click File > Export to export the capture as a CSV file. (?)

Notes

For additional information, take a look at the Beagle analyzer user manual, and Data Center manual.