-
I'm working on a project where I need to continuously capture data - I'll be running the system overnight with the BeagleTM USB 480 Protocol Analyzer. My questions:
How much data can the Beagle USB protocol analyzer capture?
Running the system overnight, will all data be captured?
What...
-
I am debugging a TI C2000 microcontroller using SPI. The setup:
The PC (personal computer) side of the SPI bus is the slave.
The packet rate is 10kHz, 100 bits/packet.
Looking at the specifications about the AardvarkTM I2C/SPI Host Adapter, I understand that when acting as a slave, ...
-
I am using the BeagleTM USB 480 Protocol Analyzer, and I want to use a decode script, such as Mass Storage, to display the transactions as class specific commands. Can the Data CenterTM Software archive the information I need? Other than doing this manually with class specifications, is it possib...
-
I’m using the AardvarkTM I2C/SPI Host Adapter to communicate with a SMBus slave device (Accuron PS401). What I'm looking to do is establish communication with the chip and verify the communication with the BeagleTM I2C/SPI Protocol Analyzer. Do you have any examples in C, for batch mode, I2C tran...
-
I have the BeagleTM I2C/SPI Protocol Analyzer, and I need to capture any glitches that may occur on an SPI bus where multiple SPI slaves are attached. How can I capture data from multiple SPI Slaves that are synchronized on an SPI bus?
Thank you for your question! Multiple SPI Slave device sig...
-
I have a question about results I see when I capture USB trace files. Using a BeagleTM USB Protocol Analyzer , I was browsing two separate USB trace files with the DataTM Center Software. On one window, the trace appeared to show some data that didn’t make sense for a short sequence in the packet...
-
-->
[caption id="attachment_3467" align="aligncenter" width="227"] The booth is ready for visitors[/caption]
Total Phase is exhibiting at the Flash Memory Summit in Santa Clara, California. We're showing off our entire range of debugging and development tools for USB, I2C, SPI, and CAN. In p...
-
The BeagleTM I2C/SPI Protocol Analyzer is a cost-effective tool for easily sniffing I2C and SPI traffic. But did you know that it could also be integrated with other systems? Here are two examples of how the analyzer can be integrated with these external systems.
[caption id="attachment_33...
-
I'm using the CheetahTM SPI Host Adapter as an SPI controller, and I need to control Cheetah with MATLAB. I've tried modifying the h. files and then generate the .m files for MATLAB, but I can't get it to work - each data type "does not exist". Can you tell me the details of what I need to do to...
-
There are many effective uses for a Beagle USB Protocol Analyzer: sniff and analyze many products, including mass storage, HIG, many classes, USB-Ethernet devices, IP-layer decoding, pass data to Wireshark and more. Colin O'Flynn, independent of Total Phase, published a review about the BeagleTM ...