-
DesignCon 2015 in Santa Clara, CA starts on January 27 and the Expo Hall opens on January 28. Total Phase is excited to exhibit this year and thinks there are plenty of reasons you should attend too.
Reasons to Attend
Total Phase is exhibiting in booth #648. Stop by and tal...
-
Question from the Customer:
I have both the Aardvark I2C/SPI Host Adapter and the Beagle I2C/SPI Protocol Analyzer. In addition to monitoring, I am trying to perform 16-bit read and write operations over SPI. The Aardvark I2C/SPI Host Adapter User Manual states that you can send two 8-bits seq...
-
Question from the Customer:
I am trying to use the Beagle I2C/SPI Protocol Analyzer and the Data Center Software to read the I2C bus to capture the data output from an LIS302DL accelerometer. The accelerometer I am using requires a clock signal from the SPI master device. Is there a way that t...
-
Question from the Customer:
I am using the Beagle USB 480 Protocol Analyzer, and have a question about the errors that the Data Center Software captures and reports. Following is a block diagram of my setup.
[caption id="attachment_4265" align="aligncenter" width="300"] Figure 1: USB Test S...
-
Question from the Customer:
I am using the Beagle USB 480 Protocol Analyzer for USB 2.0 captures. I’m trying to get information and measure timing of every IN-NAK at a specific point on an existing capture file. Using the Data Center Software, I can only get the timing of the first IN-NAK. How...
-
Question from the Customer:
I need to measure timing from an event that produces a USB response in our device. I can trigger a scope off of the edge of the event but I need another trigger when the correct packet is produced on the USB. Which one of the Beagle protocol analyzers do you recomme...
-
Question from the Customer:
We have the Beagle USB 480 Protocol Analyzer and it’s worked really well for us. We’re starting a new project that requires toggling one of the output-signals when there are specific conditions such as when the packet length=6. For these capabilities, looking at th...
-
Question from the Customer:
I will be using two Beagle I2C/SPI Protocol Analyzers to monitor SPI devices, the data from two A/D converters. I will be using the Beagle Software API and C#. Normally, I only use one Beagle analyzer - I have some questions about doing this and about the data measu...
-
The product, test and validations have been defined, the budget approved and the project is scheduled. The next question - which hardware and software tools will best support your project to monitor, capture and analyze the data on the USB 2.0 and/or USB 3.0 bus?
To make a well info...
-
Question from the Customer:
I am attempting to monitor my 4 MHz SPI application with 16-bit transfers with a slave device. I have been using the Aardvark I2C/SPI Host Adapter with the Control Center Software. When using the slave mode, data will begin to slow and then the tool "locks up" after...