What Causes Partial Error Codes to Occur When the SPI Data Is Correct?

Question from the Customer:

I’m using the Beagle I2C/SPI Protocol Analyzer and the Data Center Software. I have a question about the results I see. I send a 20-bit (2.5bytes) data packet, and the results show the data is wrong.  The error code is P4, as shown below.

Viewing error codes in Data Center SoftwareWe are certain the SPI data is correct – why is the Data Center Softwa...

How Can I Simultaneously Monitor and Respond to SPI and I2C Devices?

Question from the Customer:

I was wondering if you have a sniffer solution that allows me to test a single master on a bus? In other words, are there sniffers that respond as  slave devices with ACK and returning data?  I’m working with SPI and I2C devices.

Response from Technical Support:

Thanks for your question! For your test requireme...