How can I change SPI modes between sample and setup phases?

Question from the Customer:
I’m working with an SPI device where I need to change modes between sample and setup. I’m using the Aardvark I2C/SPI Host Adapter. How do I change the clock polarity (CPOL) and clock phase and CPHA?

Response from Technical Support:

Thanks for your question! You can easily change the clock polarity with the Cont...

Is it possible to multi-task the Aardvark I2C/SPI Host Adapter as multiple I2C slaves with separate slave addresses?

Question from the Customer:

I will be using my Aardvark I2C/SPI Host Adapter as an I2C slave to send a response to the request sent from the Master.  My question is can I use my Aardvark adapter as multiple I2C Slaves with different slave addresses? Some requirements:

  • I need to send my slave data to master every 0.25 Seconds.
  • My bus speed...

How do I set up the Komodo CAN Solo Interface to send or receive RTR frames with a device on the CAN bus?

Question from the Customer:

Can we use the Komodo CAN Solo Interface to send Remote Transmission Request (RTR) to another CAN device?  My colleagues have been trying with a CAN interface on their processor connected to the Komodo interface, but so far, there has been no response. How can we set it up so it works

Response from Technical Suppo...

Using the Aardvark I2C/SPI Host Adapter, how do I perform 7-bit register reads from an I2C slave device?

Question from the Customer:

I just purchased your Aardvark I2C/SPI Host Adapter, and I have a question. I need to read from an I2C device, using Repeated Start Condition and 7 bit addressing.  Does the Aardvark adapter support this?

Response from Technical Support:

Thank you for your question! What you described is often used when perfor...