Knowledge Base

United States

Quick Links

Knowledge Base Articles

Our technical support content consists of FAQ's and technical articles. We are constantly adding new content to this Knowledge Base, but if you can't find what you're looking for, contact our technical support team.

Filter all articles:

Article	Title
	Results per page: Page 1 of 3 << prev next >>
10000	What possible bitrates do the Aardvark I2C/SPI Host Adapter support?
10001	Why am I seeing occasional bit corruptions when using the SPI slave functionality?
10002	Why do calls to aa_i2c_slave_read, aa_spi_write, or aa_spi_slave_read produce errors for large transaction lengths?
10003	I enabled the I2C or SPI slave and started receiving messages. Now I try to disable the slave and I receive an status code of AA_COMMUNICATION_ERROR. Why can't I disable the slave? Is this a bug?
10004	Is the Aardvark I2C/SPI Host Adapter compatible with 5V I2C devices?
10005	When I power cycle my target device, the Aardvark I2C/SPI Host Adapter becomes unstable.
10006	I'm using the Aardvark I2C/SPI Host Adapter as an SPI Master and when I do a write, the Slave Select line is toggled before the data is sent. This causes an incorrect transmission from my slave device. What's wrong with my setup?
10007	I'm using the Aardvark adapter as an SPI master using mode 2 or 3. The SCK line does something strange before the actual 8 bits are transmitted. What's wrong with my setup?
10008	I am getting inconsistent and unexpected results when I try to use two Aardvark I2C/SPI Host Adapters cross-connected through the I2C/SPI Activity Board.
10009	Do I risk ruining my Aardvark device if I lose power during a firmware upgrade?
10010	My Aardvark device does not respond to the software after a firmware update. What do I do?
10014	With which operating system platforms can I use my Aardvark device?
10015	What interface does the Aardvark device use to communicate with the host PC?
10016	Will my Aardvark device work on a USB 2.0 host controller or hub?
10017	All this technical stuff is great, but where can I find some examples if I want to write some code quickly?
10019	What drivers are needed to have my Aardvark device recognized by my operating system?
10020	When I install the driver for my Aardvark adapter, Windows XP gives me a message that the Total Phase Aardvark has not passed Windows Logo testing to verify its compatibility with Windows XP. Is it safe to continue?
10021	Total Phase's device DLL philosophy is great, but where should I put the DLL/SO to make sure it is always found by my application?
10022	When running Windows, I am unable to connect to the Total Phase device immediately after I plug it in to my PC. Is this unusual?
10023	My Aardvark device-enabled application produces a fatal error when connecting to the Aardvark device. What is wrong?